PA 430 - Display with Output & Switches

Input: 4 - 20mA or 0 - 10V dc
Output: 4 - 20mA or 0 - 10V dc
Switch Output: 1 or 2 Independant PNP Open Collector
Supply Voltage: Supply Voltage of Transmitter +6V dc
Accuracy: 0.1% ± 1 digit
Approvals: zone (0) 1: II (1) 2 G EEx ia IIC T4

The plug-on display PA 430 is suitable for all transmitters with output signal 4 … 20 mA / 2-wire or 0 … 10 V / 3-wire. The plug-on display is installed between male and female plug and ready for work immediately.

Standard connector of the PA 430 is DIN 43650. Optionally versions with connectors M12x1 (5-pin) and Binder 723 series are available. Further versions are possible on request.

The display can be freely programmed via two push-buttons. Following parameters can be adjusted: scaling, decimal point, damping, and limit contact (optional). Those parameters are being stored in an EEPROM and, thus, are being kept also in case of power breakdown. Limit exceeding in both directions can be displayed as a message. The integrated smart electronics permanently monitors all functions of the display.
The unit label specified on the order is placed under the display foil and therefore is protected from wiping off. Alternatively another label with a different unit can be stuck on the display foil by the user.

• None

• None

• None